Ferrite Magnet for Printhead Cable

Features

Ferrite Magnet for Printhead Cable is available from YOUVSKEY. Review its features, technical details and handling guidance below to check suitability for your application.

• Modern DTF printers are complex environments filled with motors, heaters, and high-speed data cables.
• Electronic noise can cause the printhead to fire incorrectly.
• As print speeds increase, the frequency of the data signal also increases.
• High-Density Material: Made from a specialized ceramic compound of iron oxide mixed with nickel or zinc.
• Easy Clip-On Design: Our magnets feature a hinged plastic housing.
• Universal Fit: Available in multiple inner diameters to fit various flat flex cables (FFC) and round data lines used in DTF and UV machinery.
• To get the best noise suppression, the placement of the Ferrite Magnet is vital:

Specifications

Instructions

1. To get the best noise suppression, the placement of the Ferrite Magnet is vital:
2. Close to the Source: Place the magnet as close to the printhead carriage as possible. This stops noise right before it enters the nozzles.
3. Double Protection: For maximum results, place one magnet at the mainboard end and another at the printhead end of the cable.
4. Proper Sizing: Ensure the cable fits snugly inside the core. A loose fit reduces the effectiveness of the magnetic filter. If the cable is thin, you can "loop" it through the core once for better suppression.

Use these product-specific notes together with the supplied equipment manual and product label. Confirm compatibility and perform a small test before production.